Center Differential Ball Bearing, Replacing

Special tools and workshop equipment required 

• Press Plate:VW 401 
  Fig 1: Press Plate

  Courtesy of AUDI OF AMERICA, LLC
• Press Plate:VW 402 
  Fig 2: Press Plate VW402

  Courtesy of AUDI OF AMERICA, LLC
• Press Piece - Multiple Use:VW 412 
  Fig 3: Identifying Press Piece - Multiple Use VW412

  Courtesy of AUDI OF AMERICA, LLC
• Press Piece - 60mm:VW 415 A 
  Fig 4: Identifying Press Piece

  Courtesy of AUDI OF AMERICA, LLC
• Splitter (Kukko 17/2):VAS 251 411 

Procedure 

Fig 5: Identifying Center Differential -1- At Input Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Remove the center differential housing. Refer to CENTER DIFFERENTIAL, REMOVING AND INSTALLING .

-- Remove the center differential -1- from the output shaft.

-- Removing the ball bearing from the center differential

Fig 6: Ball Bearing Removed From Center Differential

Courtesy of AUDI OF AMERICA, LLC

A -

Splitter (Kukko 17/2):VAS 251 411 

-- Press on the ball bearing -1- using the Press Piece - 60mm:VW 415 A  -2- on the self-locking center differential -3-.