Input Shaft Seal, Replacing, Clutch Housing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
Procedure
- Clutch, engaging bearing and slave cylinder removed. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
-- With the Puller - Crankshaft/Power Steering Seal:T20143 carefully remove the seal -arrow- from the housing.
-- A waved washer -arrow- is located behind the seal, it does not need to be replaced.
- Pay attention to the installation position.
-- Drive the new seal in all the way using the Thrust Piece:T40300 .
-- Dual Clutch, Installing. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .