FLANGE SHAFT PROTECTIVE RING, REPLACING, 0B0 AND 09R "quattro ultra"

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Press Plate :VW 401

Fig 1: Press Plate
Courtesy of AUDI OF AMERICA, LLC
Press Plate :VW 402

Fig 2: Press Plate VW402
Courtesy of AUDI OF AMERICA, LLC
Press Piece - Multiple Use :VW 412

Fig 3: Identifying Press Piece - Multiple Use VW412
Courtesy of AUDI OF AMERICA, LLC
-3- Separating Tool - 22 to 115mm, for example Splitter :VAS251411

Fig 4: Commercially Available Puller Set
Courtesy of AUDI OF AMERICA, LLC
Seal Installer - Drive Flange :T10143

Courtesy of AUDI OF AMERICA, LLC
Seal Installer - Clutch Housing :T40260

Courtesy of AUDI OF AMERICA, LLC

Flange shaft removed.

Removing the protective ring A from the flange shaft

Fig 5: Identifying Separating Tool

Courtesy of AUDI OF AMERICA, LLC

B -

Separating Tool, for example, Splitter :VAS251411

Installing the protective ring 1 on the flange shaft

Fig 6: Installing the protective ring -1- on the flange shaft

Courtesy of AUDI OF AMERICA, LLC

Installation position: the larger outer diameter of the protective ring faces toward the flange.
This image above is a symbolic illustration. Use the Seal Installer - Drive Flange :T10143 .
On the final drive "09R" use the Seal Installer - Clutch Housing :T40260 for the left flange shaft.