Brake Pad Wear Indicator Wire, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
TIP:
If the clips go missing, the brake pad wear indicator wire must be replaced.
-- Insert the brake pad wear indicator contact with the retainer until it engages in the brake pad.
-- Secure the brake pad wear indicator wire back into the same position.
-- Bring the brake pad wear sensor into its installation position on the bracket and turn it in the -direction of the arrow- until the tab -2- engages in the hole -3- on the bracket.
-- Connect the connector -1-.
-- Install the brake caliper. Refer to BRAKE CALIPER, REMOVING AND INSTALLING, FOUR-PISTON BRAKE .