Wireless Data Transmission Antenna - R336- / -R366-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment and remove the ignition key.

-- Sedan: remove the left rear seat belt guide. Refer to REAR SEAT BELT GUIDE, REMOVING AND INSTALLING .

-- Avant/allroad: Remove the left luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

-- Release the retaining tabs -5- on the holder -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Pull the Wireless Data Transmission Antenna 2 -R366- -2- out off the bracket -3-.

-- Release and disconnect the connector -1-.

-- If necessary, pivot the holder -3- out of the tabs on the seat belt guide -4- -arrow-.