Near Field Communication Control Module 2 -J1170-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment and remove the ignition key.

NOTE:

The multimedia device storage compartment is shown in the illustration below without the center console.

-- Pivot the Near Field Communication Control Module 2 -J1170- -1- with the bracket -3- out of the multimedia device storage compartment -2-.

Courtesy of AUDI OF AMERICA, LLC

-- To do this, push the rubber lip on the bracket -3- using the :T40388 -A- carefully to the side and guide in the : T40388 as shown.

-- The catch on the bracket -3- is released and engages in the groove on the :T40388 -A-.

-- Use the :T40388 -A- to remove the Near Field Communication Control Module 2 -J1170- -1- and bracket -3- vertically upward from the multimedia device storage compartment.

-- Release and disconnect the connectors from the Near Field Communication Control Module 2 -J1170-.

-- Press the catches -arrows- and remove the Near Field Communication Control Module 2 -J1170- -1- from the bracket -3-.