Antenna Amplifier 2 -R111-, REMOVING AND INSTALLING, AVANT/ALLROAD: Removing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Remove the rear lid upper trim panel. Refer to REAR LID UPPER TRIM PANEL, REMOVING AND INSTALLING .
-- Release and disconnect the connectors -2- and -4- from the Antenna Amplifier 2 -R111- -3-.
-- Loosen the screw -1- several turns and remove the Antenna Amplifier 2 -R111- -3- from the rear lid.