Intermediate Shaft Speed Sensor -G265-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2024 Audi RS 3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Install the intake manifold upper section. Refer to INTAKE MANIFOLD UPPER SECTION, REMOVING AND INSTALLING .
After removing or replacing the intermediate shaft speed sensor the adaptation values for the chain length must be adapted again.
-- Connect the Vehicle Diagnostic Tester.
-- Select Diagnostic operating mode and Start diagnostics .
-- Select the Select individual test tab and select the following tree structure consecutively:
- Drive (display depends on the model)
- Select the engine code and engine (display depends on the model)
- 0001 - OBD-Capable Systems or Diagnostic-Capable System
- 0001 - Engine Electronics
- 0001 - Engine electronics, functions
- 0001 - Adaptation diagnostic chain length