Coolant Pump, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi RS 3. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Replace the O-ring after removal.
Used coolant cannot be used again.

-- Clean and polish the sealing surface for the integrated silicone seal on the coolant pump.

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

Additional procedures depending on the model. Refer to COOLANT PUMP, REMOVING AND INSTALLING .

-- Fill the coolant. Refer to COOLANT, DRAINING AND FILLING .