Exhaust Temperature Regulation Components, Removing And Installing: Removing

-- Loosen the left center underbody trim panel toward the exhaust system and push slightly downward. Refer toOVERVIEW - UNDERBODY TRIM PANELS .

Version 1:

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the tunnel heat shield. Refer to COMPONENT LOCATION OVERVIEW - HEAT SHIELD .

-- Remove the connector -arrow- from the bracket and disconnect them and then free up the wires.

Version 2:

Courtesy of AUDI OF AMERICA, LLC

-- Free up the bracket -1- at the threaded pins.

-- Free up the Particulate Filter Differential Temperature Sensor -GX41- -item 3- at the bracket.

-- Disconnect the connector -4- and free up the wires -2 and 5-.

FWD Vehicle:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Exhaust Gas Temperature Sensor 3 -G495- -arrow-.

-- Remove the Exhaust Gas Temperature Sensor 4 -G648- -arrow-.

Courtesy of AUDI OF AMERICA, LLC

AWD Vehicle:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Exhaust Gas Temperature Sensor 3 -G495- -arrow-.

-- Remove the Exhaust Gas Temperature Sensor 4 -G648- -arrow-.

Courtesy of AUDI OF AMERICA, LLC