Overview - Cylinder Block, Transmission Side: Notes
WARNING: This page is about a different car, the 2024 Audi A3 Quattro and 2024 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Intermediate Plate
- Be careful not to damage or bend when installing
- Removing and Installing. Refer to Figure.
- Alignment Sleeves
- Transmission Side Sealing Flange
- With gasket
- Replace after removing
- Removing and Installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
- Before installing, remove oil residue from crankshaft journal with a clean cloth
- The guide sleeve may only be removed after the sealing flange has been slid onto the crankshaft journal.
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Intermediate Plate
- Installed, depending on the version
- Removing and Installing. Refer to Fig 2.
- Bolt
- 25 Nm
- Flywheel
- Removing and Installing. Refer to FLYWHEEL, REMOVING AND INSTALLING .
- Only possible to install in one position
- Bolt
- Replace after removing
- 60 Nm +90°
Intermediate plate, removing and installing