Sub-Assembly Bracket, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi A3 Quattro and 2024 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Replace bolts that were tightened with an additional turn after removing them.
Replace the O-ring and seals after removing.
Used coolant cannot be used again.

-- Coat the new O-rings -4- with coolant.

Courtesy of AUDI OF AMERICA, LLC

-- Insert the connecting piece -2- in the Engine Temperature Control Adjusting Element -N493- -item 3-.

-- Push the engine oil cooler -1- with the sub-assembly bracket onto the connecting piece, position the bolts and tighten.

-- Install the oil filter element and check the oil level. Refer to ENGINE OIL .

-- Install the generator. Refer to GENERATOR, REMOVING AND INSTALLING .

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Fill with coolant. Refer to COOLANT, FILLING USING Cooling System Charge Kit:VAS 6096 [DNNA, DNNB, DNND, DNVB] .

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .