Engine Support, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi A3 Quattro and 2024 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Replace bolts that were tightened with an additional turn after removing them.
-- Install the bolt -2- before installing the engine support in the engine support hole.
-- Position the engine support and bolts -1, 2 and 3- first by hand all the way, then tighten to the specified tightening specification and sequence.
-- Install the engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
-- Install the oil filter element. Refer to ENGINE OIL .
-- Connect the coolant hoses with the connector coupling. Refer to Fig 1.
-- Check the coolant level and fill with coolant. Refer to COOLANT LEVEL, CHECKING AND FILLING .