Transmission Mount, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi A3 Quattro and 2024 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Replace bolts that were tightened with an additional turn after removing them.

-- Secure the transmission support to the longitudinal member.

CAUTION:

Risk of damaging the threads in the transmission by inserting bolts at an angle.

- Before inserting the bolts, align the transmission and the transmission mount support arm so that they are absolutely parallel to one another.

- If necessary, press up the rear transmission using a floor jack or the engine and transmission jack.

-- Check the adjustment of the subframe mount. Refer to ASSEMBLY MOUNT, CHECKING ADJUSTMENT .

-- Only remove the Engine Support Set :10-222A , when the assembly mount bolts are tightened to tightening specification. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .

-- Install the battery tray. Refer to BATTERY TRAY, REMOVING AND INSTALLING .