Flywheel, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi RS 3. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is removed. Refer to TRANSMISSION, REMOVING .
CAUTION:
Risk of damaging the thread by using an impact wrench.
- When installing, position the bolts by hand and screw in the first threads.
- Do not loosen or tighten the bolts with an impact wrench.
-- Turn the flywheel -A- so that the bolts -B- line up with the center of the holes -arrows-.
-- Place the Flywheel Retainer :3067 into the hole on the cylinder block -item B-.
-- Loosen and remove the bolts for the flywheel and remove the flywheel and sensor wheel.