Flywheel, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
Risk of destroying the engine with the friction disc not being installed.
- Check the installation of the friction disc (diamond disc) between the flywheel, sensor wheel and the camshaft stub.
- The friction disk (diamond discs) ) OVERVIEW - FLYWHEEL and ) OVERVIEW - FLYWHEEL must be replaced every time the flywheel bolts are loosened.
Do not place the sensor wheel near magnets (for example lamp base, speakers).
There is a risk of destroying the sensor wheel by magnetic force.
- Before installing the drive plate/flywheel or sensor wheel, check the function of the sensor wheel.
-- Check the sensor wheel from the engine speed sensor. Refer to SENSOR WHEEL, CHECKING .
-- After removing or replacing the sensor wheel, perform the adaptation using the => Vehicle Diagnostic Tester , 0001 - Engine electronics, functions , J623 - Engine electronics, functions
TIP:
The assembly of the flywheel, friction disk (diamond discs), and sensor wheel is only possible in one position.
- Replace bolts that were tightened with an additional turn after removing them.
-- Place the Flywheel Retainer :3067 into the hole on the cylinder block -item A-.