Engine, Securing To Engine And Transmission Holder

WARNING: This page is about a different car, the 2024 Audi RS 3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Engine Sling:2024A

Fig 1: Engine Sling : 2024A
Courtesy of AUDI OF AMERICA, LLC
Engine and Transmission Holder:VAS 6095A

Fig 2: Engine And Transmission Holder
Courtesy of AUDI OF AMERICA, LLC
Shop Crane:VAS 6100

Fig 3: Identifying Shop Crane
Courtesy of AUDI OF AMERICA, LLC
Engine Bracket:T40371 , not illustrated

Procedure

Fig 4: Hook 2024 A To Engine And To VAS 6100

Courtesy of AUDI OF AMERICA, LLC

Transmission separated from the engine.

-- Remove the catalytic converter. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Engage the Engine Sling:2024 A onto the engine and onto the Shop Crane:VAS 6100 .

To be aligned to the center of gravity of the engine, the hole rails of the lifting hook must be inserted as shown.

CAUTION:

There is a risk of injury from the lifted engine/motor falling.

The possibility for parts of the body to be pinched or crushed increases.

- Secure the mounting hooks and pins on the lifting tackle with a securing pin.

-- Secure the mounting hooks and pins on the engine support bridge using securing pins -arrows-.

-- Lower the engine from the Engine Holder Bracket:T03000 with the Shop Crane:VAS 6100 .

-- Tighten the Engine Bracket:T40371 on the cylinder block.

Courtesy of AUDI OF AMERICA, LLC

40 Nm
40 Nm
25 Nm

-- Fasten the engine to the Engine and Gearbox Bracket:VAS 6095 using the Engine Bracket:T40371 .