Transmission Mount, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi RS 3. However, it is still accessible from the selected car via links, so may be relevant.
-- Support the engine in the installation position. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .
-- Free up the wiring harness on the bracket -1- for the air filter housing.
-- Remove the bolts -arrows- and remove the bracket for the air filter housing (example illustration above).
-- Remove the Engine Control Module -J623- -1- from the bracket. Refer to Engine/Motor Control Module -J623-, REMOVING AND INSTALLING .
-- Remove the bolts -arrows- and remove the bracket -1-.
-- Remove the bolts -arrows- for the transmission mount -1-.
-- Unclip the wiring guide with the Pry Lever :80-200 and press it upward in direction of -arrows-.
- If the transmission mount is going to be re-installed, mark its installation position and the longitudinal member.
-- Remove the bolts -1- and then the transmission mount -A-.