Transmission Mount, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi RS 3. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Replace bolts that were tightened with an additional turn after removing them.

-- Fasten the transmission mount -A- on the longitudinal member.

-- When re-installing the transmission mount -1-, align it according to the markings made earlier and fasten it in place -arrows-.

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Risk of damaging threads in transmission support by inserting bolts at an angle.

- Before inserting the bolts, align the transmission support and the transmission mount support arm so that they are absolutely parallel to one another.

- If necessary, press up the rear transmission using a floor jack or the engine and transmission jack.

-- Lift the transmission using the engine support bridge spindle until the transmission support touches the support arm.

-- Remove the Engine Support Bridge :10-222A from the engine. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .

-- Install the Engine Control Module -J623-. Refer to Engine/Motor Control Module -J623-, REMOVING AND INSTALLING .