Radiator, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi RS 3. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

If there are small impressions on the slats. Refer to appropriate Service Information .
The radiator mount is reused with the separated catches. It is attached to the lock carrier. Refer to Parts Information for the correct bolts.
Replace the O-ring if it is damaged or if there are leaks.
Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.
Used coolant cannot be used again.

-- Install the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

-- Connect the coolant hose to the connector coupling. Refer to Figure.

-- Install the fan shroud. Refer to FAN SHROUD, REMOVING AND INSTALLING .

-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Fill the refrigerant circuit. Refer to appropriate service information .

-- Connect the coolant hose to the connector coupling. Refer to Figure.

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .