Overview - Radiator/Radiator Fan
WARNING: This page is about a different car, the 2024 Audi RS 3. However, it is still accessible from the selected car via links, so may be relevant.
Radiator
- Air Duct
- Radiator
- Removing and Installing. Refer to RADIATOR, REMOVING AND INSTALLING .
- Change the coolant after replacing
- Coolant Hose
- Lift the clamp to remove
- Connecting. Refer to Fig 2.
- O-Ring
- Replace after removing
- Coat with coolant
- Coolant Hose
- Air Duct
- Air Duct
- Condenser
- Removing and installing. Refer to CONDENSER, REMOVING AND INSTALLING .
- Air Duct
- Bolt
- 5 Nm
- Radiator Mount
- Radiator Mount
- O-Ring
- Replace if damaged or leaking
- Coat with coolant
- Coolant Hose
- Lift the clamp to remove
- Connecting. Refer to Fig 2.
Connect the Connector Coupling
-- Replace the damaged clamp -3-.
-- Check the O-ring -2- or Y-ring -5- for damage. The O-ring can optionally be replaced by the Y-ring. When installing the Y-ring, mind the installation position, the groove points towards the inside.
-- Coat the O-ring or Y-ring with coolant on the new component.
-- Press the coolant hose -4- on to the coolant pipe -1- until it engages audibly.
-- Press the coolant hose on again and pull to make sure the connector coupling is engaged correctly.
Fan Shroud and Radiator Fans
- Bolt
- 5 Nm
- Fan Shroud
- Removing and Installing. Refer to FAN SHROUD, REMOVING AND INSTALLING .
- Bolt
- 5 Nm
- Radiator Fan -V7-
- Removing and Installing. Refer to Radiator Fan -V7-, REMOVING AND INSTALLING .
- Radiator Fan 2 -V177-
- Removing and Installing. Refer to Radiator Fan -V7-, REMOVING AND INSTALLING .