Coolant Pump, Removing And Installing: Removing

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Remove the bolts -2 and 3- for the pendulum support.

Fig 1: Engine Support Component Location

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the right front wheel housing liner in the front area and push toward the side. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Loosen the hose clamp -arrow- and remove the air duct hose.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Support the engine in the installation position. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .

-- Remove the engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .

-- Free up the wiring harness on the bracket -1- for the air filter housing.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and remove the bracket for the air filter housing.

-- Remove the bolts -arrows- for the transmission mount -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Push the engine/transmission assembly slightly to the left side.

-- Lift the engine with the right spindle -1- to dimension -a- :

Fig 2: Identifying Engine Support Bridge - Spindle 10 - 222 A /11

Courtesy of AUDI OF AMERICA, LLC

• Dimension -a- = 55 mm

All additional procedures are described. Refer to COOLANT PUMP, REMOVING AND INSTALLING .