Overview - SUBFRAME
- Bolt
- Tightening Specification: Overview - Subframe. Refer to OVERVIEW - ASSEMBLY MOUNTS .
- Lower Bonded Rubber Bushing for Pendulum Support
- Replacing. Refer to SUBFRAME, SERVICING .
- Bolt
- 20 Nm +180°
- Replace after removing
- Install evenly
- Subframe
- There are different versions. Refer to the Parts Information.
- Securing. Refer to SUBFRAME, SECURING .
- Lowering. Refer to SUBFRAME, LOWERING .
- Removing and Installing, without Steering Gear. Refer to SUBFRAME WITHOUT STEERING GEAR, REMOVING AND INSTALLING .
- Removing and Installing, with Steering Gear. Refer to SUBFRAME WITH STEERING GEAR, REMOVING AND INSTALLING .
- Servicing. Refer to SUBFRAME, SERVICING .
- Bolt
- 70 Nm + 180°
- Replace after removing
- Not Installed
- Nut
- 65 Nm
- Replace after removing
- When tightening, counterhold on the joint pin internal multi-point bolt
- Upper Bonded Rubber Bushing for Pendulum Support
- Replacing. Refer to SUBFRAME, SERVICING .
- Stabilizer Bar with Rubber Bushings
- Removing and Installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING .
- Nut
- 65 Nm
- Replace after removing
- When tightening, counterhold on the joint pin internal multi-point bolt
- Suspension Strut
- Removing and Installing. Refer to SUSPENSION STRUT, REMOVING AND INSTALLING .
- Coupling Rod
- Removing and Installing. Refer to COUPLING ROD, REMOVING AND INSTALLING .
- Intermediate Plate
- Only for aluminum subframe
- Support
- Bolt
- 50 Nm + 90°
- Replace after removing
- Bolt
- 70 Nm + 180°
- Replace after removing