Engine, Securing To Engine And Transmission Holder

Special tools and workshop equipment required

Engine Sling :2024A

Fig 1: Engine Sling : 2024A
Courtesy of AUDI OF AMERICA, LLC
Engine and Transmission Holder :VAS6095A

Fig 2: Engine And Transmission Holder
Courtesy of AUDI OF AMERICA, LLC
Shop Crane :VAS6100

Fig 3: Identifying Shop Crane
Courtesy of AUDI OF AMERICA, LLC

Procedure

The transmission is separated from the engine. Refer to ENGINE AND TRANSMISSION, SEPARATING .

-- Remove the intermediate plate.

Fig 4: Removing Intermediate Plate

GWWN13-10562

Courtesy of AUDI OF AMERICA, LLC

-- Remove the left alignment sleeve from the cylinder block.

-- Engage the Engine Sling :2024A -1- as shown on the engine lifting eye and on the Workshop Crane :VAS6100 -2-.

Fig 5: Lifting Eye and On The Workshop Crane

GWWA10-12635

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

There is a risk of injury from the lifted motor falling.

The possibility for parts of the body to be pinched or crushed increases.

- Secure the mounting hooks and pins on the lifting tackle with a securing pin.

-- Insert the securing pins -arrows- to secure the mounting hooks and alignment pins.

-- Secure the engine to the Engine and Gearbox Bracket :VAS6095A -1-.

GWWA10-12512

Courtesy of AUDI OF AMERICA, LLC

Assembling

Assemble in the reverse order of removal. Note the following:

-- Insert the left alignment sleeve at the cylinder block.

-- Install the intermediate plate. Refer to Fig 6.

Fig 6: Installing Intermediate Plate

GWWN13-10562

Courtesy of AUDI OF AMERICA, LLC