Fuel Level Sensor -G-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Observe the safety instructions. Refer to SAFETY PRECAUTIONS .

-- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

-- Remove the fuel delivery unit. Refer to FUEL DELIVERY UNIT/FUEL LEVEL SENSOR, REMOVING AND INSTALLING .

TFSI FWD Vehicles:

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -1- on the sealing flange by unlocking the connector safety catch.

-- Disengage and free up the bleeder lines at the bracket -arrow-.

-- Release the tab on the retainers -3 and 4- and at the same time, remove the Fuel Gauge Sensor -G- -item 2- upward.

TFSI AWD Vehicles / Vehicles with a High-Voltage System

Courtesy of AUDI OF AMERICA, LLC

-- Release the connector safety catch, and disconnect the connector -4- on the sealing flange.

-- Disengage and free up the bleeder lines at the bracket -arrow-.

-- Release the tab -1 and 2- on the retainers and at the same time remove the Fuel Gauge Sensor -G- -item 3- upward.

TSI Vehicles:

Courtesy of AUDI OF AMERICA, LLC

-- Release the connector safety catch and disconnect the connector -2- from the sealing flange.

-- Disengage and free up the bleeder lines at the bracket -arrows-.

-- Release the retainers -1 and 3- -B arrows- and press out the Fuel Gauge Sensor -G- upward -arrow C-.