Accelerator Pedal Module -GX2-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Engage the bottom of the accelerator pedal module on the pedal bracket, insert the centering pin and tighten the bolt.

Depending on the engine/transmission combination, an adaptation must be performed after replacing.
If a corresponding menu item is in the engine electronics tree structure under "functions", perform the adaptation using the => Vehicle Diagnostic Tester.