Control Module, Removing And Installing: Removing

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Switch the ignition off.

-- Place the Used Oil Collection and Extraction Unit:SMN372500 under the rear final drive.

-- Remove the drain plug -1- and drain the oil.

Courtesy of AUDI OF AMERICA, LLC

-- Install the new drain plug -1- with a new gasket.

-- Disconnect the connector -1- for the AWD Control Module -J492-.

Courtesy of AUDI OF AMERICA, LLC

-- Place the Used Oil Collection and Extraction Unit:SMN372500 under the rear final drive.

-- Remove the bolts -arrows-.

-- Remove the All-Wheel Drive Control Module -J492- from the housing for the all-wheel drive clutch.