Sun Visor, Removing And Installing: Removing
WARNING: This page is about a different car, the 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Unclip the sun visor mount expanding cap -1- -arrow- by sliding the Angled Screwdriver:VAS 6416 just approximately 1 mm under the cap.
TIP:
If the long reach special wrench is inserted farther, it will be located under the sun visor mount. It is then not possible to pry out the expanding cap.
-- Disengage the sun visor from the center bearing.
-- Unclip the sun visor mount -1- with the clamp -2- downward -arrow- from the opening in the body and remove it.
-- Disconnect the connector and remove the sun visor.