Brake Caliper, Removing And Installing: Installing

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

CAUTION:

Health risk due to toxic dust from the brake system.

Irreversible deposit of dust particles in the lungs. Breathing impairments may occur.

- Never blow out the brake system with compressed air.

Use only mineral spirits to clean the brake caliper.

-- Carefully slide the brake caliper with the brake carrier and the installed brake pads over the brake rotor.

-- Install the bolts -arrows- for the brake carrier and tighten to the required tightening specification.

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connector -1-.

Make sure that the wire and brake hose are routed correctly.
Make sure the brake hose is not pinched, bent, twisted or rubbing against the vehicle.

-- If installed, disconnect the brake pad wear sensor connector -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Drive out the parking brake motor using the Vehicle Diagnostic Tester .

CAUTION:

Faulty brakes increase the risk of an accident.

- Make sure the brakes are working correctly before driving the vehicle for the first time.