Brake Pads, Removing And Installing, Six-Piston Steel Brake: Removing
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Label the brake pads when removing if they are going to be used again. Install in the same position, otherwise the braking effect will be uneven.
-- Remove the brake caliper. Refer to BRAKE CALIPER, REMOVING AND INSTALLING, SIX-PISTON STEEL BRAKE .
-- Disconnect the connector -1-.
-- Free up the wire by opening the protective cap -3- and disengage the wire from the brake caliper.
-- If the brake pads are being replaced, place the Piston Resetting Tool:T10145 with a wooden block -1- placed between it and the old brake pads and push the brake caliper pistons all the way back into the brake caliper.
-- Remove the brake pads -3 and 4- one after the other toward the center of the brake caliper.
-- Unclip the brake pad retaining plate -1-.
-- If the brake pads are replaced, unclip the top and bottom brake pad springs -2-.
- If reusing the brake pads check the brake pad spring and the brake pad retaining plate for damage, if necessary replace.
- Do not change the shape of the brake pad spring and brake pad retaining plate.