Brake Pad Wear Indicator Wire, Removing And Installing, Six-Piston Steel Brake: Removing
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the right front wheel. Refer to WHEEL, CHANGING .
-- Disconnect the connector -1-.
-- Free up the wire by opening the protective cap -2- and disengage the wire from the brake caliper.
-- Pull the Right Front Brake Pad Wear Sensor -G35- out of the brake pad, while doing so, pay attention to the clip -2-.