Brake Caliper, Removing And Installing, Six-Piston Steel Brake: Removing
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the front wheel. Refer to WHEEL, CHANGING .
-- Disconnect the connector -1- for the Right Front Brake Pad Wear Sensor -G35- on the right brake caliper.
- Pushing the brake pads -3- slightly into the brake caliper using suitable pliers -1- makes it easier to remove the brake caliper from the brake rotor.
- To prevent damage to the paint coat on the brake caliper, place a piece of rubber -2- between the pliers and brake caliper.
-- Remove the bolts -arrows-.
-- Carefully remove the brake caliper with the brake pads from the brake rotor.
CAUTION:
There is a risk of damaging the brake hose due to the weight of the brake caliper.
- Never let the brake caliper hang on the brake hose.
-- Hang the brake caliper using a suitable wire.
CAUTION:
There is a risk of damaging the brake caliper piston if handled incorrectly.
- Never activate the brakes if the brake caliper is removed.