Brake Caliper, Removing And Installing, Six-Piston Ceramic Brake: Installing

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

CAUTION:

Health risk due to toxic dust from the brake system.

Irreversible deposit of dust particles in the lungs. Breathing impairments may occur.

- Never blow out the brake system with compressed air.

Use only mineral spirits to clean the brake caliper.

-- Slide the brake caliper with the brake pads installed carefully over the brake rotor.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -arrows-.

Make sure the brake hose is routed correctly.
Make sure the brake hose is not pinched, bent, twisted or rubbing against the vehicle.

-- Connect the brake pad wear sensor connector -1-.

-- Install the front wheel, while observing the safety precautions for ceramic brakes. Refer to WHEEL, CHANGING .

-- With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly sit in their respective position.

-- Check brake fluid level, and fill if necessary.

CAUTION:

Faulty brakes increase the risk of an accident.

- Make sure the brakes are working correctly before driving the vehicle for the first time.