Dryer Cartridge, Removing And Installing, MODINE Condenser, RS 3: Installing

Install in the reverse order of removal while noting the following:

• Replace the plug, O-ring and dryer cartridge after every opening of the receiver/dryer. Refer to Parts Information.
• Keep the dryer cartridge sealed in its air-tight packaging as long as possible. Open the package just before inserting the dryer cartridge in the condenser. The dryer cartridge absorbs moisture from the surrounding air in a very short time and becomes unusable.

-- Using the opening, inspect the receiver/dryer on the condenser for dirt and damage on the threaded- and sealing surfaces.

-- Remove the dryer cartridge from the package and insert it into the filter element.

• The filter element must be pushed in until stop.

-- Coat the O-ring for the closure cap with refrigerant oil before installing. Refer to SEALS AND GASKETS .

Fig 1: Identifying Removal Of Cover And Circlip

Courtesy of AUDI OF AMERICA, LLC

-- Insert the closure cap -1- and push it far enough downward so that the snap ring -arrow- can engage in the groove.

-- Install the cap using the T50 Socket.

Courtesy of AUDI OF AMERICA, LLC

-- Evacuate and charge the refrigerant circuit. Refer to Refrigerant Circuit or Working with A/C Service Station (1 Of 2) / Working with A/C Service Station (2 Of 2) .

-- Operate the A/C system after charging the refrigerant circuit. Refer to A/C SYSTEM, STARTING AFTER CHARGING REFRIGERANT CIRCUIT .