Readiness To Send And Receive: Activating

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Risk of injury due to unintended engine start on high-voltage vehicles!

Pay attention to the high-voltage system warning messages:
For procedures where the ignition must be switched off.

NOTE:

The Full pre-delivery inspection test program may also be performed as part of the pre-delivery inspection.

Procedure:

-- Connect the Vehicle Diagnostic Tester.

-- Select Diagnostics mode.

-- Deselect "Working with Guided Fault Finding" by removing v and pressing Accept .

-- Start the diagnostic

-- Perform the vehicle identification.

-- Change to the "Special functions" tab and select the following program under the headline "Delivery service" :

Readiness to Send and Receive: Activating

-- Start the program using Perform test... .

-- Continue the program sequence.

CAUTION:

Readiness to send and receive is required to use the emergency call function. Vehicles without activated readiness to send and receive must not be handed over to the customer.