Repairing Can BUSWIRES
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Observe general notes for repairs on the vehicle electrical system. Refer to VEHICLE ELECTRICAL SYSTEM, GENERAL REPAIR INFORMATION .
- As a CAN Buswires unshielded, twisted two-wire lines -1 and 2- are used.
- When repairing CAN Buswires, both wires must be same length.
- The repair of individual wire leads is not permitted.
- The repair of CAN Buswires must take place with the matching cross section.
- For the allocation use the Electronic Parts Information (ETKA).
- No excess lengths may be created by the repair.
- While doing this, no section of the wire, for example in area of crimp connectors -arrows-, may be greater than -A- : 100 mm (3.93 in.) without twisting of the wires.
- Wrap repair locations with yellow adhesive tape to mark a performed repair.