Battery -A-, REMOVING AND INSTALLING, 0K4: Removing
-- De-energize the 48V system. Refer to 48V SYSTEM, DE-ENERGIZING .
-- Switch off the ignition and all electrical equipment. Place the ignition key outside of the vehicle.
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
-- If equipped, remove the cover -6- over the battery ground terminal post.
-- Loosen the nut -5- several turns and remove the battery ground cable terminal -4- from the battery negative terminal.
-- Open the cover -7- over the battery positive terminal.
-- Loosen the nut -2- a few turns and remove the battery terminal clamp -3- for the positive cable from the battery positive terminal.
-- Free up the wiring harness.
-- Remove the nut -3- and disengage the retaining bracket -4- on the opposite side.
-- Remove the bolt -1- at the battery bracket -2-.
-- Remove the battery -5- from the battery tray and lift upward out of the engine/motor compartment.
- The disposal regulations for batteries and sulfuric acid must be followed when disposing of batteries. Refer to Battery .