Right Multifunction Buttons on Steering Wheel -E441- /Left Multifunction Buttons on Steering Wheel -E440-, REMOVING AND INSTALLING, STEERING WHEEL WITH TRAPEZOIDAL AIRBAG: Removing

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

-- Remove the driver airbag. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .

-- Draw sketches or take pictures of the wire routing in the steering wheel. This will ensure the original wire routing when installing.

-- Remove the catches -arrows- on the steering wheel trim -1- from the catches in the steering wheel -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Use the Trim Removal Wedge:3409 to release the multifunction button -1- close to the retainer in the direction of -arrow B-.

Courtesy of AUDI OF AMERICA, LLC

-- Pry out the multifunction button -1- on the other side in the direction of -arrow A- using the Trim Removal Wedge:3409 .

-- Release and disconnect the connectors on the multifunction button.