Information Electronics Control Module 1 -J794-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .

-- Release and disconnect the connectors -3- from the Information Electronics Control Module 1 -J794- -1-.

Courtesy of AUDI OF AMERICA, LLC

-- For vehicles with TV-Tuner -R78- put the Fiber-Optic Repair Set - Connector Protective Caps:VAS 6223/9 -1- onto the connector of the MOST Bus -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the wiring harnesses from the bracket -4- -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -2-.

-- Tilt out the bracket -4- with the Information Electronics Control Module 1 -J794- -1- downward.

-- Insert the two Radio Removal Tools:T10057 -A- into the release slots on the Information Electronics Control Module 1 -J794- -1-.

Courtesy of AUDI OF AMERICA, LLC

The points on the grip eyelets of the Radio Removal Tool:T10057 face outward.
Both Radio Removal Tools:T10057 must engage.

-- Remove the Information Electronics Control Module 1 -J794- -1- from the bracket -2- at the Radio Removal Tool:T10057 grip eyes -A-.

-- Press the locking tabs on the Information Electronics Control Module 1 -J794- and remove the Radio Removal Tool:T10057 -A-.