Component Location Overview - Antenna Systems, Sedan
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicle Interior Communication Antenna -R364-
- Removing and Installing. Refer to Vehicle Interior Communication Antenna -R364-, REMOVING AND INSTALLING .
- Near Field Communication Antenna -R269-
- Only for Japan (ER5)
- Removing and Installing. Refer to the appropriate Service Information .
- Vehicle Interior Communication Antenna 2 -R365-
- Removing and Installing. Refer to Vehicle Interior Communication Antenna 2 -R365-, REMOVING AND INSTALLING .
- Roof Antenna -R216-
- Antenna assignment depends on equipment
- Removing and Installing. Refer to ROOF ANTENNA, REMOVING AND INSTALLING .
- Bolt tightening specification: 5Nm.
- Antenna Amplifier 2 -R111-
- Removing and Installing. Refer to Antenna Amplifier -R24- / Antenna Amplifier 2 -R111-, REMOVING AND INSTALLING, SEDAN .
- Screw tightening specification: 2 Nm
- Windshield Antenna Suppression Filter -C18-
- Removing and Installing. Refer to Windshield Antenna Suppression Filter -C18-, REMOVING AND INSTALLING, SEDAN .
- Nut tightening specification: 9 Nm
- LTE Antenna 3 -R330-
- Only on 9ZE
- Removing and Installing. Refer to BUMPER ANTENNAS, REMOVING AND INSTALLING, LIMOUSINE .
- LTE antenna tightening specification to the bracket: 3.5 Nm
- Bracket tightening specification to the body: 3.5 Nm
- Emergency Call Module Antenna 2 -R322-
- Only for IV1/IV2/IV3/JE1/JE3/JE6
- Removing and Installing. Refer to BUMPER ANTENNAS, REMOVING AND INSTALLING, LIMOUSINE .
- Emergency call module antenna tightening specification: 3.5 Nm
- Bracket tightening specification to the body: 3.5 Nm
- TV Antenna Amplifier 3 -R84-
- Removing and Installing. Refer to TV Antenna Amplifier 3 -R84-, REMOVING AND INSTALLING, SEDAN .
- Screw tightening specification: 2 Nm
- Antenna Amplifier -R24-
- Removing and Installing. Refer to Antenna Amplifier -R24- / Antenna Amplifier 2 -R111-, REMOVING AND INSTALLING, SEDAN .
- Screw tightening specification: 2 Nm
- Near Field Communication Control Module 2 -J1170-
- Only for Mobile Key (2F1)
- Removing and Installing. Refer to Near Field Communication Control Module 2 -J1170-, REMOVING AND INSTALLING .
- Near Field Communication Antenna 2 -R351-
- Only for Mobile Key (2F1)
- Removing and Installing. Refer to Near Field Communication Antenna 2 -R351-, REMOVING AND INSTALLING .
- Near Field Communication Antenna -R350-
- Only for Mobile Key (2F1)
- Removing and Installing. Refer to Near Field Communication Antenna -R350-, REMOVING AND INSTALLING .