Headliner, Lowering, Sedan

Special tools and workshop equipment required 

• Pry Lever:80-200 

  Courtesy of AUDI OF AMERICA, LLC

• Removal Wedge:T40233 

  Courtesy of AUDI OF AMERICA, LLC

• Omega Clip Tool:T40280 

  Courtesy of AUDI OF AMERICA, LLC

• Scraper no. 1 from the Scraper Set:VAS 6845 

  Courtesy of AUDI OF AMERICA, LLC

• Clip release lever no. 5 from the Scraper Set:VAS 6845 

Procedure

-- Pay attention to the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .

-- Move the rear headrests into the lowest position.

-- Remove the sun visors. Refer to SUN VISOR, REMOVING AND INSTALLING .

-- Remove the center support for the sun visor. Refer to SUN VISOR CENTER SUPPORT, REMOVING AND INSTALLING .

-- Remove the vanity mirror lamp. Refer to DRIVER VANITY MIRROR LAMP -W20- /FRONT PASSENGER VANITY MIRROR LAMP -W14-, REMOVING AND INSTALLING .

-- Remove the roof grab handle. Refer to ROOF GRAB HANDLE, REMOVING AND INSTALLING .

-- Remove the A-pillar upper trim panels. Refer to A-PILLAR UPPER TRIM PANEL, REMOVING AND INSTALLING .

-- Detach the B-pillar upper trim panels (refer to B-PILLAR UPPER TRIM PANEL, REMOVING AND INSTALLING ) and move to the side with the seat belt.

-- Remove the D-pillar trim panels. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING, SEDAN .

-- Remove the C-pillar upper trim panel. Refer to C-PILLAR UPPER TRIM PANEL, REMOVING AND INSTALLING, SPORTBACK .

-- Free up in the headliner in the area of the inner door seals.

Courtesy of AUDI OF AMERICA, LLC

• Replace the headliner if it is bent.

-- Unclip the rear headliner at the clip -3- from the body -right arrow- using the Pry Lever:80 - 200  .

-- Unclip the headliner from the body in the center at the centering pin -2-.

-- Carefully lower the back of the headliner.

-- Unclip the cover -1- on the side using the clip-release lever from the Scraper Set:VAS 6845  -arrows A, B and C-.

Courtesy of AUDI OF AMERICA, LLC

-- Disengage the front cover and remove toward the rear.

Versions without Sliding Sunroof:

-- Remove the front roof module. Refer to FRONT INTERIOR LAMP/READING LAMP, REMOVING AND INSTALLING .

-- Lower the headliner and place it on the seats.

Versions equipped with a sliding sunroof:

Courtesy of AUDI OF AMERICA, LLC

-- Open the sunroof shade.

-- To avoid dirtying the headliner, clean the Removal Wedge:T40233  .

-- Push the trim removal wedge between the sunroof frame -1- and the headliner.

-- Using the trim removal wedge, loosen the headliner all the way around the sunroof frame -arrows-.

-- Unclip the headliner -3- together with the front roof module -2- from the clamp -1- using the scraper from the Scraper Set:VAS 6845  -arrows- and carefully lower it.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector and free up the wiring harness.

-- Lower the headliner and place it on the seats.

Assembling

-- Align the headliner, press in the centering pin at the back of the headliner until it engages audibly in the body mounting point.

-- Install the center support for the sun visors. Refer to SUN VISOR CENTER SUPPORT, REMOVING AND INSTALLING .

-- Stretch the inner door seal lip over.

Versions equipped with a sliding sunroof:

-- Clip the sides of the headliner into the sunroof frame first, and then into the front and rear.

Further assembly is performed in reverse order.