Rear Lid Trim, Removing And Installing, Sedan: Removing

Courtesy of AUDI OF AMERICA, LLC

-- Unclip the rear lid latch trim panel -1- using the Removal Wedge:T40233  in the -direction of the arrow-.

-- Open the cover and remove the emergency triangle from the bracket to do so press the catch.

Courtesy of AUDI OF AMERICA, LLC

-- Release the retaining tabs using a flat-head screwdriver -arrows- and remove the emergency triangle bracket -1-.

-- Unclip the stop strip -1- using the Trim Removal Wedge:3409  -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Repeat the procedure on the opposite side.

-- To remove the expanding clips -1-, push the clamping pin -2- in carefully approximately 5 mm until it engages audibly in the expanding clip -arrow- (do not push in completely, otherwise the clamping pin will be lost).

Courtesy of AUDI OF AMERICA, LLC

-- Remove the released expanding clip with a clamping pin.

-- Pull the rear lid hinge trim panel -3- downward out of the rear lid trim panel and remove it.

-- Repeat the procedure on the opposite side.

-- Remove the bolt -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Unclip the rear lid trim panel -1- starting at the top of the rear lid -A arrows- using the Pry Lever:80 - 200  .

Courtesy of AUDI OF AMERICA, LLC

-- Unclip the side of the rear lid trim panel from the rear lid -B arrows-.

-- Unclip the lower rear lid trim panel from the rear lid -C arrows- and remove.