Overview - Oil Pan/Oil Pump
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Suction Line
- Clean the screen if there are debris
- Bolt
- Replace after removing
- 4 Nm +45°
- O-Ring
- Replace after removing
- coat with engine oil
- Bolt
- Replace after removing
Aluminum bolt
- 8 Nm +90°
Steel bolt
- 16 Nm + 90°
- Replace after removing
- Oil Pump
- Removing and Installing. Refer to OIL PUMP, REMOVING AND INSTALLING .
- Alignment Sleeve
- Quantity: 2
- For the oil pump
- Oil Screen
- O-Ring
- Replace after removing
- coat with engine oil
- Bolt
- -Item 2-
- Oil Pressure Regulation Valve -N428-
- -Item 3-
- Oil Pump Drive Chain
- Mark the running direction before removal
- Guide Pin
- 9 Nm
- Chain Tensioner
- Cylinder Block
- Oil Pan Upper Section
- Removing and Installing. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- Tightening sequence. Refer to Fig 3.
- Plug
- Oil Pan Lower Section
- Removing and Installing. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
- Seal
- Replace after removing
- Nut
- 9 Nm
- Oil Level Thermal Sensor -G266-
- Removing and Installing. Refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING .
- Seal
- Replace after removing
- Fluid Drain Plug
- 30 Nm
- Bolt
- Replace after removing
- Tightening sequence. Refer to Fig 2.
Oil Pan Lower Section - Tightening Specifications and Sequence
- Replace bolts that were tightened with an additional turn after removing them.
-- Tighten the bolts -1 to 20- in steps in the sequence shown:
| Step | Tightening specification/additional turn |
|---|---|
| 1. | Install all the way by hand |
| 2. | 8 Nm |
| 3. | 45° additional turn |
Oil Pan Upper Section - Tightening Specifications and Sequence
- Replace bolts that were tightened with an additional turn after removing them.
-- Tighten the bolts in the steps in the sequence shown:
| Step | Bolts | Tightening specification/additional turn |
|---|---|---|
| 1. | -1 through 18- | 8 Nm |
| 2. | -1 and 2- | 180° additional turn |
| 3. | -3 to 13- | 45° additional turn |
| 4. | -14 through 18- | 90° additional turn |