Oil Separator, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the cylinder ignition coils "3 and 4". Refer to IGNITION COILS, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and move the engine lifting eye -1- to the side.

Courtesy of AUDI OF AMERICA, LLC

-- If installed, disconnect the connector -1- for the Tank Ventilation Pressure Sensor 1 -G950-.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamp -1- and remove the hose from the EVAP Canister Purge Regulator Valve 1 -N80-.

Courtesy of AUDI OF AMERICA, LLC

-- Press the release buttons on both sides and remove the crankcase ventilation hose -2-.

-- Remove the bolts -arrows- and the oil separator (example illustration).