Overview - Rear Lid Trim Panel, SPORTBACK
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Clip
- Quantity: 8
- Insert in the trim panel
- Remove any clips remaining in the rear lid mounting points using the Omega Clip Tool: T40280 . To install, insert into the trim panel.
- Replace damaged or deformed clips
- Emergency Release Cover
- Unclip using the Trim Removal Wedge: 3409
- Clipped in the rear lid trim panel
- Expanding Rivet
- Quantity: 2
- Press on until stop
- Lower Trim Panel
- Removing and Installing. Refer to REAR LID LOWER TRIM PANEL, REMOVING AND INSTALLING, SPORTBACK .
- Press on until it engages audibly
- Clip
- Quantity: 10
- Insert in the trim panel
- Remove any clips remaining in the rear lid mounting points using the Omega Clip Tool: T40280 . To install, insert into the trim panel.
- Replace damaged or deformed clips
- Rear Lid Latch Trim Panel
- Removing and Installing. Refer to REAR LID LOWER TRIM PANEL, REMOVING AND INSTALLING, SPORTBACK .
- Press on until it engages audibly
- Speed Nut
- Quantity: 2
- Clip into rear lid
- Tail Lamp Cover
- Quantity: 2
- Clipped in the rear lid trim panel
- Bolt
- Quantity: 2
- 2 Nm
- Upper Trim Panel
- Removing and Installing. Refer to REAR LID UPPER TRIM PANEL, REMOVING AND INSTALLING .
- Press on until it engages audibly
- Luggage Compartment Cover Bracket
- Quantity: 2
- Clip into the trim panel