Wheel Bearing Unit, Removing And Installing, Fwd With Multi-Link Suspension: Removing

WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Dust Cap (1 Of 2)

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the dust cap from the seat by tapping lightly with a hammer on the claw of the Puller - Grease Cap: VW637/2 -1-.

-- Dismount the dust cap using the Puller - Grease Cap: VW637/2 -1-.

Fig 2: Removing Dust Cap (2 Of 2)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the brake rotor. Refer to BRAKE ROTOR, REMOVING AND INSTALLING .

Fig 3: Identifying Wheel Hub/ Bearing Unit

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

There is a risk of damaging the bolt if handled incorrectly.

- Never use an impact wrench to loosen or tighten.

- Position the bolt by hand only and screw in the first threads.

-- Remove the bolt -1- with the Socket - Xzn 18mm: T10162A .

-- Remove the wheel bearing unit -2- from the axle stub.

Handling the wheel bearing. Refer to Figure.