Wheel Bearing Unit, Removing And Installing, Fwd With Multi-Link Suspension: Installing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Replace the dust cap and bolt after removal.
-- Carefully slide the wheel bearing unit onto the axle stub.
- Make sure that the wheel bearing unit does not tilt!
CAUTION:
There is a risk of damaging the bolt if handled incorrectly.
- Never use an impact wrench to loosen or tighten.
- Position the bolt by hand only and screw in the first threads.
-- Drive in the new dust cap all the way using the Camshaft Installer Kit - Sleeve : 3241/4 -1-.
-- Install the brake rotor. Refer to BRAKE ROTOR, REMOVING AND INSTALLING .