Overview - Wheel Bearing, AWD
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Wheel Bearing Housing
- Removing and Installing. Refer to WHEEL BEARING HOUSING, REMOVING AND INSTALLING .
- Bolts
- 90 Nm + 90°
- Replace after removing
- Drive Axle
- Overview. Refer to OVERVIEW - DRIVE AXLE .
- Speed Sensor
- Right Rear ABS Wheel Speed Sensor -G44-
- Left Rear ABS Wheel Speed Sensor -G46-
- Overview. Refer to OVERVIEW - REAR AXLE SPEED SENSOR .
- Bolt
- Tightening specification. Refer to OVERVIEW - REAR AXLE SPEED SENSOR .
- Bonded Rubber Bushing
- Replacing. Refer to WHEEL BEARING HOUSING BONDED RUBBER BUSHING, REPLACING .
- Brake Shield
- Removing and installing. Refer to BRAKE SHIELD, REMOVING AND INSTALLING .
- Bolts
- Tightening specification. Refer to OVERVIEW - REAR BRAKES .
- Bolt
- Tightening specification. Refer to OVERVIEW - REAR BRAKES .
- Brake Rotor
- Removing and installing. Refer to BRAKE ROTOR, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- Bolt, Loosening and Tightening. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .
- Clean the threads in the CV joint with a thread tap before installing.
- Wheel Bearing Unit
- With sensor ring for ABS speed sensor
- Check sensor ring. Refer to ABS SENSOR RING, CHECKING
- Removing and Installing. Refer to WHEEL BEARING UNIT, REMOVING AND INSTALLING, AWD .
- Cannot be disassembled
- Handling the wheel bearing. Refer to Figure.