Spring, Removing And Installing, Torsion Beam Axle: Removing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the wheel. Refer to WHEELS AND TIRES .
-- Remove the locking ring -1- in the direction of -arrow- until it stops.
-- Install the spring tensioner -1-.
- Spring Compressor Kit - Spring Tensioner: VAG1752/1
- Spring Compressor Kit - Spring Retainer with Inserts: VAG1752/3A
CAUTION:
There is a risk of injury if the coil spring pops out suddenly.
It is possible that parts of the body may become bruised.
- Note the instructions that follow.
- Make sure the coil spring is seated correctly in the Spring Compressor Kit - Spring Retainer with Inserts: VAG1752/3A -2-.
-- Tension the coil spring and remove it.
TIP:
Use a wrench or a reversible ratchet to tighten the spring compressor.