Spring, Removing And Installing, Multi-Link Suspension: Installing

WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Spring Start Touching Spring Seat

Courtesy of AUDI OF AMERICA, LLC

The spring start -arrow- must touch the stop of lower spring support.

-- Install the spring and the spring support.

-- Insert the pin of the lower spring support in the hole of the lower transverse link -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Insert the top of the spring support into the upper spring end.

Fig 2: Locating Spring Support Bead

Courtesy of AUDI OF AMERICA, LLC

The bead on the spring support -arrow- must fit into the coil spring correctly.

-- Release the tension on the spring, guiding upper spring support onto tab of body.

-- Remove the spring compressor.

-- Insert the assembly aid -1- and press downward until the tabs -arrows- engage.

Courtesy of AUDI OF AMERICA, LLC

-- Overview table for when an axle alignment is needed. Refer to NEED FOR AXLE ALIGNMENT, EVALUATING .